S008769 Rev A 67
Maintenance
8. Once the separator roller and the skimmer rollers have been cleaned, reset the maintenance
reminder for cleaning the Feed Rollers located in the Maintenance Monitor section of the
NOU’s Home Screen
- With the NOU active and communicating with
the scanner (see ”2.2
Ngenuity Operator
Utility” on page 29), click on the Replace
hyperlink associated with “Clean Feed
Rollers” in the Maintenance monitor of the
Home screen
- A confirmation dialog window will display.
Confirm the Feed Rollers have been cleaned
by clicking the YES button. This will reset the
reminder to begin monitoring for the next
required maintenance session
REPLACING THE SEPARATOR ROLLER
With proper cleaning, BBH estimates the life of the separator roller to equate to approximately
600,000 pages fed. Different document types, the condition of the documents being scanned,
and the volume of scanning may alter that number slightly.
For optimal performance, if having to replace the separator roller, replace the tires of the skimmer
rollers (pick and drive - 4 tires total) at the same time (see 5.3.1 Feed Rollers, “
Replacing Tires”
on page 63).
To replace the separator roller, perform the following:
1. Power OFF the scanner (see 1.4.2 Scanner Back, “
Power Switch” on page 11)
2. Open the scanner’s transport cover (see 1.4.1 Scanner Front, “
Transport Cover” on page 7
and “
Transport Cover Release Levers” on page 7)
3. Remove the separator roller (see “Cleaning the Separator Roller” on page 66)
4. Remove the roller itself from the rest of the assembly as shown in the Exploded View image
of the separator roller found under ”5.3.1.2
Separator Roller” on page 65
5. Reassemble the components using a new roller, duplicating the assembly shown in the
Exploded View image of the separator roller found under ”5.3.1.2
Separator Roller” on
page 65
6. Reinstall the separator roller into the scanner (see “Cleaning the Separator Roller” on
page 66)
7. Discard the old roller
To Next Page
Loading...
