S008769 Rev A 19
Operating Your Scanner
2.1.1.2 Back Door LED
The BACK DOOR LED indicator displays the status of the scanner’s straight pass-
through door located in the back of the scanner (see ”1.4.2
Scanner Back” on
page 11). When lit, the BACK DOOR LED indicator is green in color.
The table below identifies the various actions of the BACK DOOR LED depending upon the state
of the scanner’s straight pass-through door:
2.1.1.3 Maintenance LED
When lit, the MAINTENANCE LED indicates that maintenance or service
conditions exist in the scanner (see ”2.2.2.3
Maintenance Monitor” on page 35 for
more information). When lit, the MAINTENANCE LED is yellow in color.
Power State or Transition Pushbutton Function
OFF N/A - control panel and scanner electronics not powered
READY Pushbuttons are ignored during this initialization transition
SLEEP > READY Pushbuttons are ignored during this initialization transition
READY/ACTIVE All pushbuttons perform their normal operational functions. Press
and hold the STOP pushbutton for 5 seconds to put the scanner
immediately to sleep
READY > SLEEP Momentary press of any pushbutton re-triggers the sleep timer and
prevents transition to SLEEP mode; scanner resumes a READY
mode
SLEEP Momentary press of any pushbutton wakes up the scanner (starts
the SLEEP > READY transition)
Back Door State Back Door LED
Straight pass-through door is closed; normal
full transport path to exit tray is in use
OFF (not lit)
Straight pass-through door is open; docu-
ments being scanned will be transported to
rear exit rather than normal exit tray
STEADY ON
To Next Page
Loading...
