S008769 Rev A 17
Operating Your Scanner
Operating Your Scanner
The scanner’s control panel and the Ngenuity Operator Utility are detailed in this section.
2.1 Control Panel
The control panel is located on the front of the scanner (see
”1.4.1
Scanner Front” on page 6). It is comprised of pushbutton
switches, LED indicators, universal graphics (pictogram legends),
and text legends that allow the Operator to manipulate basic
scanner controls.
Through the use of the LED indicators and audible tones (see
”2.2.3.4
Audio” on page 38), the control panel also acts as a
notification device for the Operator as to the current state of the
scanner (e.g. power state, maintenance needed, active features,
errors, etc.). It is divided into five sections:
•Status
• Feeder Table
• Custom Functions
• Scan Monitor
• Batch Control
Some of the functionality contained within these sections
correlates with the settings and information found in the Ngenuity
Operator Utility, which is discussed in greater detail in
”2.2
Ngenuity Operator Utility” on page 29.
N
OTE
The control panel remains powered during SLEEP mode;
however, it will be un-powered during the OFF mode, i.e.,
powered OFF (see ”2.1.1.1
Power Mode LED” on page 18 for
more information).
To Next Page
Loading...
