S008769 Rev A 11
Getting Started
1.4.2 Scanner Back
Ref# Item Name Description
1Back Imprinter
Door
The back imprinter is installed and accessed through this door. It requires
an additional 3.5” (9 cm) of clearance to open fully (see Side View-2 on
page 4). For more information about the imprinter, see ”4.1 Imprinter” on
page 53.
2 Straight Pass-
Through Door
Enables the use of the Straight Pass-Through scanning feature. When the
straight pass-through door is open, documents are fed straight through the
scanner and exit out the back of the scanner. This is useful for scanning
thick or stiff documents. The straight pass-through door requires an
additional 3.5” (9 cm) of clearance to open fully (see Side View-2 on
page 4).
NOTE
While scanning documents in rotary mode (straight pass-
through feature NOT being used), do NOT open the straight
pass-through door. Doing so can cause a physical paper jam or
cause the scanner’s firmware to issue a paper jam error.
3SCSI
Connector
Connector for attaching optional SCSI cable (cable and SCSI card not
provided). For more information about the optional SCSI connection, see
”4.2
SCSI Connection” on page 53.
4 USB
Connector
Connector for attaching supplied USB cable which also attaches to the
host PC and is used to establish communication between the two.
5 Power Switch Toggle switch used to apply or remove power to the scanner. ‘I’ = ON; and
‘O’ = OFF.
To Next Page
Loading...
