18 S008769 Rev A
Ngenuity Operator Manual
2.1.1 Status
The Status area of the control panel consists of the
following LED indicators: POWER MODE; BACK DOOR;
MAINTENANCE; and MANUAL FEED.
2.1.1.1 Power Mode LED
The POWER MODE indicator uses an LED to indicate the various power states
(modes) or the transition between power modes. When lit, the POWER MODE
LED indicator is green in color.
The table below identifies the various actions of the POWER MODE LED depending upon the
scanner’s power state:
Once in SLEEP mode, the POWER MODE LED is the only indicator that will be lit; all others are
off (not lit) in order to reduce power consumption.
Depending on the current power mode, the control panel’s pushbuttons perform different actions.
The table below identifies the functionality of the control panel’s pushbuttons during the various
power modes and transitions:
Power State or Transition Power Mode LED
OFF Off
READY Blinking, fast rate
SLEEP > READY Blinking, fast rate
READY/ACTIVE Steady
READY > SLEEP Blinking, fast rate
SLEEP Blinking, slow rate @ 10% duty cycle
To Next Page
Loading...
