24 S008769 Rev A
Ngenuity Operator Manual
• With the feeder full (i.e. paper sensor covered), the UP pushbuttom performs no function. A
DOWN pushbutton press will set the current stack size and reset the feeder bottom position
accordingly.
2.1.3 Custom Functions
The next area of the control panel is labeled Custom Functions.
The Custom Functions section contains two pushbutton
switches, F1 and F2, that perform special Operator-selectable
functions.
The functions that the F1 and F2 pushbuttons perform are
assigned through the Ngenuity Operator Utility (NOU) where
there is a pre-defined list of functions that the Operator can choose from (see 2.2.3.3 Custom
Functions for more information).
2.1.4 Scan Monitor
The third area of the control panel is the Scan Monitor section
which contains error indicators in the form of LEDs that notify
the Operator that an error has occurred while scanning. The
error indicators are: ERROR; COVER; PAPER JAM; MISFEED;
and MULTIFEED.
Within the Scan Monitor section is also a pushbutton labeled MF
IGNORE. This pushbutton allows the Operator to ignore a
single multifeed occurrence
Each error indicator LED and the MF IGNORE pushbutton are
described in more detail in the following sections.
2.1.4.1 Error LED
When lit, the ERROR LED indicator is yellow in color. It is lit when any scanner
error occurs that is not handled by one of the other dedicated indicators (i.e. Paper
Jam, Cover, Misfeed, etc.).
If the ERROR LED is lit, refer to the NOU and your scanning application for more
information.
To Next Page
Loading...
