S008769 Rev A 75
Maintenance
CAUTION
If using forced air to clean the sensors, do NOT turn the can of forced air upside down or tip it
sideways more than 40 degrees while using. The extension tube can be bent so as to avoid
having to tip the can.
CLEANING THE FEEDER SENSOR
The feeder sensor detects paper on the feeder table. Dust and small particles of paper may build
up on the sensor, causing the feeder table not to lower after the last page fed. Regular cleaning
of the feeder sensor will reduce this problem.
Item(s) Needed
•Blower Brush
• Forced Air (optional, not supplied)
C
AUTION
Avoid using any type of cotton swab or any item that may leave lint behind. These types of
cleaning items can cause further problems with sensors functioning properly.
WARNING
Make sure to power OFF the scanner before applying forced air to the sensors.
Feeder Sensor
Cork Pad
Separator
Roller Door
Feeder Table
To Next Page
Loading...
