10.4 Handling
10.4.1 Transport
—
Climate category 2K3 according to EN61800-2, IEC 60721-3-2
—
Temperature -25...+70°C, max. 20K/hr change
Humidity rel. humidity 5% - 95% , no condensation
— Only by qualified personnel in the manufacturer’s original recyclable packaging
— Avoid shocks, especially to the shaft end
— If the packaging is damaged, check the motor for visible damage. Inform the carrier
and, if appropriate, the manufacturer.
Transport of motors with a weight of more than 20kg
Lifting eyes must be used to safely transport AKM7 and AKM8 motors (> 20kg).
Observe any transport instructions included in the packaging of the motor.
We recommend the transport tool ZPZM 120/292 for moving the motors.
Suspension Unit ZPMZ 120/292 consists of a beam, suspended to the crane hook and
two double-run chain suspenders.
Suspended load. Risk of death if load falls. Never step under the load,
while the motor is raised.
— The fastening screws of the lifting eyes must be fully screwed in.
— The lifting eyes must be positioned on the supporting surface in an even and flat
manner.
— Prior to use, check the lifting eyes for secure fitting and any obvious damages (cor-
rosion, deformation).
— Lifting eyes with deformations must not continue to be used.
Servomotors AKM English - 37
Kollmorgen 04/2013 Safety
ENGLISH
To Next Page
Loading...
