Kopp Labormaster HCT 3000 User Manual

Labormaster Version 2.6.3 SW 2.2 from 03/2016 Page 15 of 82, March 1, 2016
Subject to errors and technical changes!
3.Device description
The highest accuracy is achieved through the real-time operating system and
hardware timer.
Thermal contact hot sealing: Interchangeable, permanently heated sealing rails at the
bottom and top heat the carrier material and sealing medium (polyethylene,
sealing wax...). The sealing medium bonds when heated under the pressure of the sealing
rails.
The wide setting range of the sealing time and the high accuracy, even with very
short sealing times, enable production conditions to be recreated.
The user chooses the starting point of the sealing time himself:
Sealing temperature: In two independent control circuits (one for the lower
PLC controlled. The setting is made via the central control panel. On the display
Speed: TFT display displayed.
The dynamic speed control enables hot tack measurement even at low take-off
speeds. The trigger device initially starts at maximum acceleration. The seam is
then separated at the preset take-off speed. The seam separation speed corresponds
to half the take-off speed.
Seal system:
Both times are displayed.
Seal seam strength tester Labormaster HCT 3000
Operating instructions and technical description
Works linearly from top to bottom and is thus optimally distributed over the
entire sealing contact area. The lower sealing jaw is optimally centered on the pressure
transmitter using a steel ball.
The dwell time allows you to specify a defined time before the seal seam
strength test to measure the cold seam strength (cold tack).
Dwell time:
seal and
Page - 15 -
Trigger PLC controlled. Is set via the central control panel and in
sealing rail, one for the upper sealing rail), two temperature controllers integrated into
the PLC control and regulate the temperature.
When touching the sealing rails, when reaching the preset maximum force or
when reaching a freely definable force within these limits.
The target value is set precisely to the degree via the central control panel.
E-Mail: sales@kopp-online.de
Ulmer Straße 51 – 53
Willi Kopp e. K
Fax +49.7153.9510-100
http://www.kopp-online.de
Phone +49.7153.9510-0
Inh. Ludwig P. Goals
D-73262 Reichenbach/Fils
Packaging systems
Machine Translated by Google

Kopp Labormaster HCT 3000 Specifications

General

Brand	Kopp
Model	Labormaster HCT 3000
Category	Laboratory Equipment
Language	English