Page - 34 -
4. The value now set and displayed corresponds to the actual sealing force, whereby the thickness
of the material to be sealed is not taken into account.
1. Press the “Sealing jaws” button on the central control panel.
Adjust sealing force
3. Press the “Sealing jaws” button on the central control panel again.
The sealing force is displayed in the parameter setting screen at the bottom right.
Open the sealing jaws.
Seal seam strength tester Labormaster HCT 3000
the desired value is shown in the display.
Operating instructions and technical description
Turn clockwise: Turn
counterclockwise: Reduce sealing force.
5.3.2.
Increasing sealing power
The sealing jaws close pneumatically.
5. Set the sealing time to 3 s and check or correct the preselected sealing force by closing the sealing
rails several times.
2. With the jaws closed, turn the adjustment handle (Figure 3 / device overview p. 19 (1)) until
D-73262 Reichenbach/Fils
Willi Kopp e. K
E-Mail: sales@kopp-online.de
Ulmer Straße 51 – 53
http://www.kopp-online.de
Fax +49.7153.9510-100
Inh. Ludwig P. Goals
Phone +49.7153.9510-0
Packaging systems
Subject to errors and technical changes!
Labormaster Version 2.6.3 SW 2.2 from 03/2016 Page 34 of 82, March 1, 2016
Machine Translated by Google
To Next Page
Loading...
Need help?
General