1. Use the TAB key to move the cursor (highlighted in blue) to the one you want to change
Note: None when using PTFE-coated sealing bars
To switch off the heating of the upper sealing jaw, the “Top heating” button on the control panel must be
pressed. The indicator light on the button goes out.
Set temperatures above 250 °C. PTFE has a temperature resistance of approx.
250 °C; higher temperatures can destroy the coating on the rails.
Temperature value.
Page - 35 -
If alarm limits for the temperature are active and the actual temperature is outside the set limits, the text
fields “Top temperature” and “Bottom temperature” are highlighted in red.
To switch the heating back on, press the “Heating down” button again. The indicator light on the
button lights up.
Attention: Heated sealing jaws and sealing rails are still hot even after the device
has been switched off!
Set sealing temperature
The set temperature is reached when the target value matches the actual value.
Seal seam strength tester Labormaster HCT 3000
Note: Pressing the delete key DEL deletes the digit to the left of the cursor.
Operating instructions and technical description
To switch the heating back on, press the “Top heating” button again. The indicator light on the
button lights up.
(The heating time to a sealing temperature of 150°C is approx. 20 minutes).
5.3.3.
During the warm-up time, a dark bar appears below the target temperature.
In order to switch off the heating of the lower sealing jaw, the "Lower heating" button on the control panel
must be pressed. The indicator light on the button goes out.
2. Use the number keys to overwrite the current target value with the new target value.
5.3.3.1. Switch off the heating of the sealing jaws
3. Confirm your entry with the ENTER key.
D-73262 Reichenbach/Fils
Willi Kopp e. K
E-Mail: sales@kopp-online.de
Ulmer Straße 51 – 53
http://www.kopp-online.de
Fax +49.7153.9510-100
Inh. Ludwig P. Goals
Phone +49.7153.9510-0
Packaging systems
Labormaster Version 2.6.3 SW 2.2 from 03/2016 Page 35 of 82, March 1, 2016
Subject to errors and technical changes!
Machine Translated by Google
To Next Page
Loading...
Need help?
General