MPS-10
-
Parameter guide
88
2 Select the INST to move.
3 Select the category to which you want to move the INST.
4 Move the cursor to “Execute” and press the ENTER button. The following confirmation
message is shown.
Note:
If there is already data in the move destination category with the same name as the one you are moving
when you press “Execute”, the message shown below appears.
If you move the data in this state, the existing data is not overwritten, but new data with the same
name is registered in that category.
5 Press the ENTER button to finish moving.
Changing the registered category for all data within a category
In this example, we move all INST data in the “Root” category to “UserCategory001”.
1 Select “INST Category ...” on the Data Management/Move page, and press the ENTER button.
Tip:
To move the SAMPLE data within a category, select “SAMPLE Category ...” here.
To Next Page
Loading...
