Korg MPS-10 - Page 89

MPS-10 - Parameter guide
89
2 Select the category from which you want to move the data.
3 Select the category to which you want to move the data.
4 Move the cursor to “Execute” and press the ENTER button. The following confirmation
message is shown.
Note: If there is at least one SAMPLE data item in the move destination category with the same name, the mes-
sage shown below appears.
If you move the data in this state, the existing data is not overwritten, but new data with the same
name is registered in that category.
5 Press the ENTER button to finish editing the registered category.
Note: It may take some time if you try to move a lot of data all at once.