Korg mr-2 - Advanced Recording Settings; Input Level and Gain Control

22
PlugInPower
ActivatingPlug‐In‐PowerwillsupplypowertotheMICINjack.Ifthis
parameterissetto“On,”besuretoconnectacondenser‐typemicrophone
thatsupportsPlug‐In‐Power.Ifyouconnectanothertypeofmicrophone
(suchasadynamicmicrophoneoramicrophonewithabuilt‐inbattery),
themicropho
nemaybedamaged.
Monitor
Setthisparameterto“Off”toavoidfeedbackorsavethebatterypower.
Thisparametersettingisinvalidduringplayback.
Input Level
Indicatesthecurrentinputlevel.UsetheINPUT
LEVELbuttononthesidepaneloftherecorderto
adjusttheinputlevel.
Manual (Manual Gain Control mode)
Ifyouareab
leto
predicttheaudiolevelofthe
sourceyouarerecording,checkthisbox,thenuse
theINPUTLEVELbuttontomanuallyadjusttheinputlevel.
Auto (Auto Gain Control mode)
Iftheaudiolevelwillbechangingsignificantly,orifyouintentionally
wanttolimitthedynamicrange,checkthisbox,thense
tthef
ollowing
three“A u t o Level”parameters.
The“A u t o ” settingwillautomaticallyadjusttherecordinglevelin
responsetotheinputlevels.
Target
TheMR‐2willautomaticallyadjusttherecordinglevelsothatthe
peaklevelwillnotexceedthevaluespecifiedhere.
0–−24dB,1dBsteps:defaultsettingis−12dB
/s
In
c. (Gain increment)
Thegainwillbeboostedclosertothe“Target”valuebytheincre‐
mentspecifiedhere.
Off,+1–+24dB/s,1dBste ps:defaultsettingis+1dB/s
Dec. (Gain decrease)
Thegainwillbecutbytheamountspecifiedhereifitexceedsthe
“Target”value.
Off,−1–−24dB/s,1d
Bste
ps:defaultsettingis−1dB/s