Kostal PLENTICORE plus - Page 96

96
4
© 2018 KOSTAL Solar Electric GmbH
Operation and operating the device
n
Communication
Set the communication parameters for the inverter’s
Ethernet connection.
Parameter Explanation
Network IPv4 Activate the network protocol and
configure the network interface (Ether-
net) for the inverter.
The "Automatic" option is activated by
default.
If configuring manually, the corre-
sponding parameter values should be
entered.
Set the DNS server:
The "Automatic" option is activated by
default.
If configuring manually, the corre-
sponding parameter values should be
entered.
Modbus SunSpec (TCP) Activate the protocol
n
Solar portal
Input of solar portal configuration. If you want to use a
solar portal, the log data and events can be sent to the
solar portal.
Parameter Explanation
Solar portal Selection of solar portal.
Activate Activated for starting to send to a
solar portal.
INFO
The "Automatic" option is activat-
ed by default. This means that the
inverter acquires its IP address from a
DHCP server or automatically gener-
ates an IP address.
If the inverter is not allocated an au-
tomatic IP address through a DHCP
server, the inverter can be configured
using "Manually".
The data necessary for configuration,
such as IP, router addresses etc., can
be found on your router/gateway.
2
3
4
5
6
7
8
9
10
11
12
13
1