Kramer MV-6 User Manual

MV-6 – Contents
i
Contents
1 Introduction 1
2 Getting Started 2
2.1 Achieving the Best Performance 2
2.2 Safety Instructions 3
2.3 Recycling Kramer Products 3
3 Overview 4
3.1 Accessory to Medical Equipment (IEC 60601-1) 5
3.2 Defining the MV-6 3G HD-SDI Multiviewer 5
4 Installing in a Rack 9
5 Connecting the MV-6 10
5.1 Connecting to the RS-232 Port 11
5.2 Connecting via Ethernet 12
6 Operating the MV-6 Locally 16
6.1 Using the Display 16
6.2 Adjusting the Size of a Window 16
6.3 Adjusting the Position of a Window 17
6.4 Defining and Saving a Custom Window Layout 17
6.5 Recalling a Window Layout 18
6.6 Freezing/Releasing a Video Output 18
6.7 Locking the Front Panel 18
6.8 Resetting the Device to Factory Defaults 19
6.9 Using the Menu 19
7 Operating the MV-6 Remotely 23
7.1 Operating the MV-6 via the RS-232 Serial Port 23
7.2 MV-6 Controller Software 23
7.3 The Menu Bar 25
7.4 Upgrading the Firmware 36
8 Technical Specifications 37
9 Default Communication Parameters 38
10 Kramer Protocol 3000 Syntax 39
10.1 Host Message Format 39
10.2 Device Message Format 39
10.3 Command Terms 40
10.4 Entering Commands 41
10.5 Bidirectional Definition 41
10.6 Command Chaining 41
10.7 Maximum String Length 42
10.8 Backward Support 42
11 Protocol 3000 Commands 43
11.1 System Commands - Mandatory 43
11.2 System Commands 48
11.3 Video Commands 52
11.4 Multiviewer Commands 55
11.5 Communication Commands 61
12 Parameters 65
12.1 On/Off 65
12.2 Color Space 65
12.3 Genlock Types 65

Kramer MV-6 Specifications

General

Brand	Kramer
Model	MV-6
Category	Switch
Language	English