The MV-6 is housed in a 2U height enclosure and is fed from a 100-240 VAC
universal switching power supply. The device can be controlled via the front panel
buttons and remotely via:
RS-232 serial commands transmitted by a PC, touch-screen system or other
serial controller
Ethernet over a LAN
3.1 Accessory to Medical Equipment (IEC 60601-1)
In the modern medical environment remote access is essential, for example, to
transfer clinical data between doctors and to train to medical students. The MV-6
is certified according to the IEC 60601-1-2, Clause 2.1.3, Medical Electrical
Equipment, Part 1: General Requirements for EMC standard which is required
when accessory devices are used at locations where medical personnel and
patients are present.
The MV-6 constitutes an optional component that can be considered necessary
and suitable as part of medical equipment or for use as part of a medical system to
provide real time simultaneous video feeds to those present at the local medical
environment and at remote locations. In this environment, the MV-6 can be added
to the system ONLY if the connecting equipment has been evaluated and meets
the IEC 60601-1-2 EMC standards. Note, that when attaching accessory devices
to a digital or analog interface, they must comply with the IEC standard for which
they are used: EMC Standard (IEC 60601-1-2), Information Technology equipment
(IEC 60950-1 (2ed)).
3.2 Defining the MV-6 3G HD-SDI Multiviewer
This section defines the MV-6.
To Next Page
Loading...
Need help?
General
