Safety
22
Pos: 19.25 /BA/Sic herheit/1. Grun dlegende Sich erheitshinweise /Betriebssich erheit - Technis che Grenz werte_Verweis auf Maschbeschr Te chn Daten @ 1 76\mod_1372 857251111_7 8.docx @ 15 06647 @ @ 1
Technical limit values
If the technical limit values of the machine are not observed, the machine may be damaged. As
a result, accidents may occur and people may be seriously injured or killed. Observance of the
following technical limit values is particularly important for safety:
– Permitted gross weight
– Maximum axle loads
– Maximum payloads
– Maximum trailer load
– Maximum bearing load
– Maximum transport height
– Maximum speed
• Observe limit values, see chapter Description of machine, "Technical data".
Pos: 19.26 /Übersc hriften/Überschrif ten 3/F-J /GGefahrenbereic he @ 187\ mod_13800124 27290_78.doc x @ 1606906 @ 3 @ 1
3.4.9 Danger zones
Pos: 19.27 /BA/Sic herheit/1. Grun dlegende Sich erheitshinweise /Gefahrenbereic he rund um A nhängegerät, A nbaugerät o. Anh änger T1 @ 176\mod_1 372858104099_7 8.docx @ 15 06686 @ @ 1
Danger zones on the tractor and the machine
The area around the tractor and the machine is a danger zone.
There are the following hazards in this danger zone:
– The tractor and the machine may start moving or rolling away and run over people.
– If the power lifter is unintentionally actuated, the machine may make hazardous
movements.
– Defective or insecurely attached electrical cables may cause fatal electric shocks.
– Defective or insecurely attached hydraulic or pneumatic lines may become detached and
flail around. Hydraulic oil may escape under high pressure and cause serious injuries to the
skin or face.
– Clothing may become caught and wrapped around an exposed PTO shaft or a damaged or
incorrectly installed universal shaft.
– When the drive is switched on, machine parts may rotate or swivel.
– Hydraulically raised machine parts may descend unnoticed and slowly.
Pos: 19.28 /BA/Sic herheit/1. Grun dlegende Sich erheitshinweise /Gefahrenbereic he rund um A nhängegerät, A nbaugerät o. Anh änger T2 @ 273\mod_1 404140364724_7 8.docx @ 20 59727 @ @ 1
If the danger zone is not observed, people may be seriously injured or killed.
• Keep people away from the danger zone of the tractor and the machine.
• Do not switch on the drives and engine until there is nobody in the danger zone.
The safety clearance is:
– 3 metres on either side of the machine.
– 5 metres behind the machine.
• Before working in front of and behind the tractor and in the danger zone of the machine: •
Shut down and safeguard the machine, see chapter Safety, "Shutting down
and safeguarding the machine". This also applies to brief inspection work. Many serious
accidents in front of and behind the tractor and the machine occur due to negligence and
running machines.
• Consider the information in all relevant operating instructions.
– The operating instructions for the tractor
– The operating instructions for the machine
– The operating instructions for the universal shaft
Pos: 19.29 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
