Krone Big Pack 1270 - Threading in the Upper Twine

Terminal – Menus [Medium/Comfort Version Electronics]
236
Pos: 103.305 /Üb erschriften/Übersc hriften 2/A-E /A/Alarmmeld ungen @ 19\ mod_123857 2457463_78.doc x @ 221082 @ 2 @ 1
16.15 Alarm messages
Pos: 103.306 /BA/I nfo-Center/ WARNUNG- Personen-/Maschi nenschäden Nic htbeachtung von Alarmen! V erweis auf Alar mmeldungen @ 3 66\mod_144 1112564352_7 8.docx @ 26 89885 @ @ 1
WARNING!
Personal injuries and/or machine damage caused by non-observance of alarm
messages!
When alarm messages are ignored and the malfunction is not remedied, personal injuries
and/or serious damage to the machine could result.
• When alarm message is displayed, remedy the malfunction.
• For possible causes and how to remedy them, refer to chapter entitled “Alarm
Messages”.
• In case the malfunction cannot be remedied, contact KRONE customer service.
Pos: 103.307 /BA/I nfo-Center/CC I-ISOBUS-Ter minal/CCI-BiG Pack/Haupt menüs/Alarm meldungenAlarmel dung allgemein @ 404\mod_ 14490523325 66_78.docx @ 2870296 @ @ 1
CC000053_2
Fig.
146
The display shows an alarm message if a malfunction occurs on the machine. At the same time
an audio signal will be heard (continuous horn sound). For description, possible cause and
remedy, refer to chapter Terminal - Menus, “Alarms”.
Acknowledging the alarm:
• Press in order to acknowledge the alarm.
The acoustic signal stops.
If the malfunction occurs again, the alarm message will also appear again.
Pos: 103.308 /BA/I nfo-Center/CC I-ISOBUS-Ter minal/CCI-BiG Pack/Haupt menüs/Alarm meldungen/Alarm meldung: Beschrei bung der S oftkeys @ 267\ mod_1400682 339813_78.docx @ 2021661 @ @ 1
Softkey
Description
Information
Acknowledge alarm
– The alarm message will appear
again if the malfunction occurs again
Delete message
– This message is not shown until the
operation terminal is started the next
time.
Pos: 103.309 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_119 6175311226_0. docx @ 4165 @ @ 1