8 Terminal – machine functions [Medium Plus/Comfort Plus Electronics]
8.20 Trigger knotter
42
Supplement to Operating Instructions 150000773_00_en
BiG Pack 1270, BiG Pack 1270 XC, BiG Pack 1290, BiG Pack 1290 HDP, BiG Pack 1290 HDP XC, BiG Pack
1290 XC, BiG Pack 890, BiG Pack 890 XC
8.20 Trigger knotter
Press
.
8.21 Raising/lowering blade cassette
Release
Press
.
ð The
and icons are displayed.
Raising
Press and hold
.
Lowering
Press and hold
.
8.22 Setting the target bale channel flap pressure (manual mode)
NOTICE
If an excessively high target bale channel flap pressure is set, the machine may be
mechanically overloaded during baling. This may damage the machine.
The display shows one of the alarm messages "Baling force exceeded" (
,
,
).
To prevent damage to the machine, if the alarm message "Baling force exceeded" occurs
more frequently, reduce the target bale channel flap pressure.
The bale channel flap pressure is entered by the user in manual mode. The pressure is built up
immediately if the PTO shaft is running and the machine is stopped. The pressure display
barely fluctuates on the display. To prevent damage to the machine, the bale channel flap
pressure is reduced to a non-critical value just before the system overloads. After several
seconds, the pressure set by the user is built up again. The bale channel flap pressure is
displayed in bar or PSI depending on selected system of units.
20
4 cm
38 %
94 / 240 cm
2 / 4
1
2
EQG000-030
To Next Page
Loading...
