Operation
249
Pos: 107.1 /Übersc hriften/Überschrif ten 1/A-E/ Bedienung @ 0\mod_119978 9505403_78.d ocx @ 34825 @ 1 @ 1
18 Operation
Pos: 107.2 /BA/Sic herheit/2. V orangestellte W arnhinweise/WARNUN G - Nic htbeachtung d er grundlegend en Sicherheits hinweise alte For m @ 254\mod _13974857935 75_78.docx @ 1953347 @ @ 1
WARNING!
If the basic safety instructions are not followed, people may be seriously injured or
killed.
• To avoid accidents, the basic safety instructions in the chapter Safety must have been
read and followed, see chapter Safety "Basic safety instructions".
Pos: 107.3 /BA/Sic herheit/2. Vora ngestellte W arnhinweise/WARNUN G - Nic htbeachtung d er Sicherheitsrouti nen alte For m @ 273\mod _1404117435996 _78.docx @ 2058712 @ @ 1
WARNING!
If the safety routines are not adhered to, people may be seriously injured or killed.
• To avoid accidents, the safety routines in the chapter Safety must be read and followed,
see chapter Safety "Safety routines".
Pos: 107.4 /BA/Sic herheit/2. Vora ngestellte W arnhinweise/Achtu ng - Press vorgang mit m aximalem Druck ges tartet - ALT E FORM @ 362 \mod_1439815 983709_78.do cx @ 2671856 @ @ 1
ATTENTION! – Machine may be damaged if the baling process is started at maximum
baling pressure.
If the baling process is started at maximum baling pressure, the friction clutch on the flywheel
may be damaged.
• Do not start the baling process at maximum baling pressure.
Pos: 107.5 /BA/Be dienung /Groß packenpresse /Pressen vorber eiten @ 325\m od_14258942 23332_78.doc x @ 2501756 @ 2 @ 1
18.1 Preparation for baling
Before you start baling, check to make certain
– the bale ejector is in the front position.
– the bale brake is locked.
– the tying twine reserves are adequate.
– the correct cutting length is set, for the cutting system version.
– the working height of the pick-up is set.
– the correct bale length is set via the terminal.
– the knotter shaft is unlocked as otherwise an endless bale will be pressed.
– the flywheel brake is released.
• Lower bale chute into working position.
• Lower pick-up into working position.
• Set bale length and baling pressure via terminal.
Pos: 107.6 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175 311226_0.doc x @ 4165 @ @ 1
To Next Page
