Maintenance
347
20.7.3 Pick-up drive (III)
Fig.
Right and left sides of the machine
At the factory the spring has been preset (1) to a = 60 mm.
• Open the protective cover on the right or left side of the machine
• Unscrew the counter nut (2)
• By screwing in the bolt (3), increase the tension of the spring (1)
• Secure the bolt (3) with the counter nut (2)
• Close protective cover
Pos: 114.39 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1
To Next Page
