Table of Contents
3
Pos: 3 /Überschrif ten/Überschrif ten 1/F-J/Inhaltsverzeic hnis @ 31\mod_12519699 52727_78.docx @ 302165 @ 1 @ 1
1 Table of Contents
Pos: 4 /BA/Inhaltsver zeichnis Sprachenne utral @ 10\mod_1221574899 104_0.docx @ 135495 @ @ 1
1 Table of Contents ................................................................................................................................... 3
2 Foreword ................................................................................................................................................. 6
3 To this Document ................................................................................................................................... 7
3.1 Validity ................................................................................................................................................ 7
3.1.1 Direction Information ................................................................................................................... 7
3.2 Representation and Utilization of Warning Notes .............................................................................. 7
3.3 Identification of the hazard warnings .................................................................................................. 7
3.4 Purpose of Use ................................................................................................................................... 8
3.5 Intended Use ...................................................................................................................................... 8
3.6 Service life of the machine ................................................................................................................. 8
3.7 Safety Instructions and Accident Prevention Regulations ................................................................. 9
3.7.1 Personnel Qualification and Training ........................................................................................ 10
3.7.2 Dangers in Case of Non-compliance with the Safety Instructions ............................................ 10
3.7.3 Safety-conscious work practices ............................................................................................... 10
3.8 Attached devices .............................................................................................................................. 11
3.9 PTO operation .................................................................................................................................. 11
3.10 Hydraulic system .............................................................................................................................. 12
3.11 Maintenance ..................................................................................................................................... 13
3.12 Unauthorised Conversion/Modification and Spare Parts Production ............................................... 13
3.13 Inadmissible Modes of Operation ..................................................................................................... 13
4 Machine Description ............................................................................................................................ 14
4.1 Machine overview ............................................................................................................................. 14
4.2 Identification Plate ............................................................................................................................ 22
4.3 Information Required for Questions and Orders .............................................................................. 22
4.3.1 Contact ...................................................................................................................................... 22
4.4 Introduction ....................................................................................................................................... 23
4.4.1 Re-Ordering the Adhesive Safety and Information Labels ....................................................... 23
4.4.2 Affixing the Adhesive Safety and Information Labels ............................................................... 23
4.5 Position of the Adhesive Safety Stickers on the Machine ................................................................ 24
5 Technical Data of the Machine ............................................................................................................ 40
5.1 Technical data .................................................................................................................................. 40
5.2 Consumables ................................................................................................................................... 46
5.2.1 Filling Quantities and Lubrication Designations for Gearboxes ................................................ 46
6 Commissioning..................................................................................................................................... 47
6.1 Special Safety Instructions ............................................................................................................... 47
6.2 First installation ................................................................................................................................ 47
6.3 Adapting to the tractor ...................................................................................................................... 47
6.4 Mounting onto the Tractor ................................................................................................................ 48
6.4.1 Clutching points ......................................................................................................................... 48
6.4.2 Lower suspension arm .............................................................................................................. 49
6.5 PTO shaft ......................................................................................................................................... 50
6.5.1 Length adjustment..................................................................................................................... 50
6.6 Preparation on the front-mounted disc mower ................................................................................. 51
6.6.1 Install the PTO shaft.................................................................................................................. 51
7 Start-up .................................................................................................................................................. 52
To Next Page
Loading...
