Krone EasyCut F 360 CV - Adjusting the Conditioner Plate; Adjustment for Swathing

Settings
76
Pos: 70.37 /Übersc hriften/Überschri ften 2/A-E/Einstell en des Aufbereitungsb lechs @ 0\mod_1196670615681 _78.docx @ 10399 @ 2 @ 1
10.4 Adjusting the conditioner plate
Pos: 70.38 /Abkürzun gen /CV-Ausführung @ 95\ mod_1328530180147_78. docx @ 799128 @ @ 1
CV-Design
Pos: 70.39 /BA/Einste llungen/Mähwerke/Ea syCut/Einstell ung des Aufbereitungsb leches Bild 360 CV/CR @ 245\m od_1395989855917_7 8.docx @ 1915844 @ @ 1
EC-499-0
Fig. 47
Pos: 70.40 /BA/Einste llungen/Mähwerke/Ei nstellung des Aufber eitungsbleches Text EC280/320 CV-Q -1 @ 59\mod_129742 9715286_78.doc x @ 558136 @ @ 1
The degree of conditioning is changed by adjusting the lever (1).
In the “+” direction: Degree of conditioning is increased
In the “-” direction: Degree of conditioning is decreased
Always check the tedder for damaged tines before the machine is used:
Straighten any bent tines.
Replace any broken tines.
Pos: 70.41 /Übersc hriften/Überschri ften 3/A-E/E/Einste llung bei Schwadablage @ 3\ mod_1204713732476_78. docx @ 72183 @ 3 @ 1
10.4.1 Adjustment for Swathing
Pos: 70.42 /BA/Er stinbetriebnahme/Easy Cut/F 360 CV/CR/Einst ellung der Schwadablag e EC F 360 CV/CR Bild/Text @ 250\mod_13 96958850805_78.doc x @ 1937660 @ @ 1
EC-500-0
1
1
2
Fig. 48
The swath width is set by swath flaps at the rear side of the machine. The swath flaps are
locked by ring nuts (2).
Pos: 70.43 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1