XI - 1
Return to Service
11 Return to Service
Special Safety Instructions
• The following general rules apply to all maintenance, assembly, repair and adjustment work:
Bring the machine to a complete standstill. Switch off the engine, remove the ignition key
and disconnect the 12 V supply voltage.
• Secure the tractor and round baler against rolling.
• If the tailgate is open, secure it at the shut-off tap to prevent it from falling.
• Avoid skin contact with oil, grease, cleaning agents and solvents.
• In case of injuries or burns caused by oils, cleaning agents or solvents, seek immediate
medical attention.
• After completing maintenance work reattach all protective plates and protective devices
properly.
• Please observe all other specific safety instructions.
11.1 General Information
• Before returning to service, start the binding or net wrapping mechanism manually and turn the mechanism
by hand.
Check the starter systems of the twine or net wrapping mechanism.
• Grease all lubrication points and lubricate the chains. Wipe away any grease which oozes out of the bearings.
• Check the oil level in the main drive gear box and top up according to specification if necessary.
• Check hydraulic hoses and lines for leaks; replace if necessary.
• Check tyre pressure and add air if necessary.
• Check that all bolts are fastened tightly and tighten if necessary!
• Check all electrical connection cables and the lighting; repair or replace if necessary.
• Check all settings on the round baler and correct if necessary.
• Clean the brake disk (2) of any rust on the bearing
surface (1).
To Next Page
Loading...
