Krone Round Pack 1550 - Adjusting Baling Pressure (Medium)

V - 9
Basic Settings and Operation
Replace blades
• Pull the blade (1) through the blade shaft slot (2).
• Insert blade.
• Lock the blade shaft.
Relock the blade shaft.
KRS-1-015
1
2
5.4 Adjusting Baling Pressure (Me-
dium)
Baling pressure is preselected using the adjusting
segment (3) located behind the front right guard and is
set from inside the twine box via the wing nut on the
righthand side.
Never perform the baling pressure
adjustment with the system in automatic
mode.
Baling pressure preset:
• Manually raise the baling pressure indicators (1) to the
desired position.
• Loosen the wing nut (2) in the twine box and move the
bolt with wing nut in the slot until the control unit
(Medium) indicator lights go out and the horn sounds.
• Tighten the fly nut inside the twine box.
RP-0-018
2
3
0
1
RP-A-035
1
2
RP-99-007
KR208250
1
3
2
When working in straw all blades (1) can be disassembled
and attached on the bolt (3) with spring pin (2) under the
right-hand front guard.