Krone Round Pack 1550 - 1 General Information; Intended Use; Technical Data; Manufacturers Address

I - 1
General Information
1 General Information
This operating manual contains basic instructions to
follow for assembly, operation and maintenance.
For this reason, these operating instructions must be
read by operating personnel before commissioning
and use, and need to be available for easy reference.
Follow both the general safety instructions contained
in the section on safety and the specific safety
instructions contained in the other sections.
1.1 Intended Use
The Round Pack 1250; Round Pack 1250 MultiCut;
Round Pack 1550 and Round Pack 1550 MultiCut
round balers are collecting balers equipped with bale
chambers.They compact agricultural baling material
such as hay, straw or silage into round bales. The
Round Pack 1250 fixed bale chamber makes it
possible to compact round bales with a diameter
of approximately 1.25 m, the Round Pack 1550
compacts bales 1.55 m in diameter. The round bales
are 1.20 m wide. The round balers are equipped with a
twin twine and/or net wrapping system.
1.2 Technical Data
1.2.1 General Information
This operating manual is valid for the Round Pack 1250;
Round Pack 1250 MultiCut; Round Pack 1550 and
Round Pack 1550 MultiCut round balers beginning with
serial no. 540 680.
1.2.2 Manufacturer's Address
Maschinenfabrik Bernard Krone GmbH
Heinrich-Krone-Straße 10
D-48480 Spelle (Germany)
Telephone: (49) 59 77/935-0
Fax: (49) 59 77/935-339
E-mail: Info.ldm@krone.de
1.2.3 Certification
EC Declaration of Conformity
corresponding to the EC Directive
See reverse side of title page
1.2.4 Identification
Type
Year
Vehicle
ID No.
The entire identification plate
represents a legal document and
should not be altered or rendered
illegible!
1.2.5 Data Required for Questions and
Orders
When making questions concerning the machine or
ordering replacement parts, be sure to provide type
designation, vehicle ID number and year of
manufacture.
Genuine replacement parts and
accessories authorized by the
manufacturer help ensure safety.
Use of other parts may void liability
for damage which results.
The machine data are listed on an identification plate
(1).This is located on the right-hand side of the machine
under the twine box.
Maschinenfabrik Bernard Krone GmbH
Heinrich-Krone-Str. 10 D-48480 Spelle
Made in
Germany