XI - 2
Return to Service
11.2 Vent Overload Coupling on
the PTO Shaft
(friction clutch only)
Following extended downtimes, overload coupling
surfaces (2) may stick to the contact surfaces. Vent
the overload coupling before use.
• Undo the bolts (1) crosswise.
• Turn the PTO shaft manually.
• Tighten the bolts crosswise.
KR-0-151
1
1
2
Following extended downtimes check the smoothness in
operation of all components of the bale density indicator
and make sure that the mechanism is not dirtied.
For this:
• Clean rope guide tube (1) at regular intervals.
• Check cross shaft (2) and guide pin (3) for smooth
operation and clean if required.
RP-5-004
2
1
3
To Next Page
Loading...
