Krone Round Pack 1550 - Baffle Plate

V - 2
Basic Settings and Operation
5.2 Baffle Plate
Adjust the height and supporting pressure of the baffle
plate (1) to crop conditions.
Basic Setting:
high swathes = position “a”
low swathes = position “b”
Baffle Plate Height
• Remove the linch pin (2).
• Insert the pin (4) into the desired bore hole from the
inside.
• Secure in place using the linch pin (2).
Supporting Pressure
• Hook the spring (3) into the desired bore hole (5).
• Always adjust both sides.
• In cases of extremely short harvest material, unhook
the spring (3) entirely.
VP-A-003
4
3
1
a
2
b
5
For extreme ground conditions, regulate the working
depth using the low limiter:
• Raise the pick-up hydraulically.
• Push the feeler wheels (3) upwards.
• Slacken the nuts (2).
• Slide the depth control (1) forwards.
• Tighten nuts (2).
• Always adjust both sides.
1
2
RBV19220
For usage with straw, the pick-up should
be set as high above the ground as
possible. Use the height adjuster (1) to
do this and set the pick-up feeder wheels
so that they are not in contact with the
ground.
5.2.1 Roll-type crop guard
Adjust the height of roll-type crop guard (1) to crop
conditions.
Basic Setting:
high swaths = position “a”
low swaths = position “b”
Height of the roll-type crop guard
• Remove the nut.
• Move the screw and socket (2) to the desired bore
hole.
• Secure in place using the nut.
RP600034
1
a
b
2