Precision Seed Drills
62
MAXIMA 2 M
Instructions for work
Fitting distribution disks
- Open hood (1).
- Install distribution disk (2) on drive shaft (3).
- Close hood (1).
Always fit a distribution disc in each seeding
unit, used or not, in order to allow correct
machine functioning.
Before changing a disk, empty the seeding
unit hopper.
Mark disks prior to removing them in order to
determine their respective position. A disk
must always be fitted on the same sowing
unit.
Respect disc direction of mount:
The disk face with the identification
engraving (4) must be placed on the suction
side.
When disks are fitted with agitator blades,
position disks with agitator blades pointing
inwards.
When the discs are fitted with a groove,
position the discs with the groove pointing
outwards.
Check that the distribution disk is properly
positioned on the drive shaft.
To Next Page
Loading...
