6-46
Program Mode and the Program Editor
The FXMOD2–FXMOD4 Pages
The FXMOD2–FXMOD4 Pages
These pages are a continuation of the KDFX page. Unlike the KDFX page, these pages each list
five FXMods, and they don’t indicate the current studio. Otherwise, they’re identical to the
KDFX page, listing the five parameters that make up each FXMod.
EditProg:FXMOD2||||||||||||||All|Layers|
Bus:|Param:|||||Adjust:||Source:||Depth:
FX1||Mix|Lvl||||5.5dB||||OFF||||||0dB|||
FX2||VibChInOut|Out||||||MIDI22|||1|||||
FX2||Vib/Chor|||V2|||||||FXFUN1|||5|||||
FX2||Lo|Rate||||-0.50Hz||FXASR2|||-6.20H
FX2||Hi|Rate|||||0.50Hz||FXASR2||||6.20H
<more||KDFX|||FXMOD2|FXMOD3|FXMOD4|more>
The FXLFO, FXASR, and FXFUN Pages
If you’ve read the descriptions of LFOs, ASRs, and FUNs that begin on page 6-40, you already
know most of what you need to know about these three pages. They contain the parameters for
the two LFOs, two ASRs, and four FUNs that the K2661 provides for KDFX control. With two
exceptions, these control sources operate like the “regular” LFOs, ASRs, and FUNs. The
differences are that the FX versions are global (they affect all layers in a program instead of
individual layers), and they’re available only for control of KDFX. Otherwise they’re the same as
the regular LFOs, ASRs, and FUNs (the regular versions can be used to control KDFX as well). In
fact the descriptions for the regular LFOs, ASRs, and FUNs apply to their KDFX counterparts.
Please see pages 6-40 through 6-44 if you need more information.
The ImportKDFX Page
You can import studios and FXMods from existing programs or setups. Press the ImpFX soft
button to bring up the ImportKDFX page.
EditProgram:ImportKDFX||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
From|Program|1|Concert|Piano|1||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||(Studio|49|Sndbrd|Room|Hall|||)||||
||||||||||||||||||||||||||||||||||||||||
Prog||Setup||||||||||||||||Import|Cancel
There’s just one parameter, which tells you the program or setup from which to import. Use the
Prog or Setup soft button to toggle between the list of programs and the list of setups. In this
case, we’re about to import the studio and FXMods from Program 1 Concert Piano 1 (which
uses Studio 49 Sndbrd Room Hall). As you scroll through the list of programs or setups, the
display indicates which studio is assigned to the program or setup.
When you press the ImpFX soft button, the K26610 copies the studio and FXMod settings from
the specified program or setup, and applies them to the current program. You then return to the
page you were on when you pressed the ImpFX soft button.
To Next Page
Loading...
