Kurzweil K2661 - QA Formats and MIDI Transmission

10-16
MIDI Mode
Program Change Formats
QA Formats and MIDI Transmission
If you’re in Quick Access mode and you’re using one of the QA formats for the program change
type, selecting QA banks or bank entries from the K2661 (with the alphanumeric buttonpad, the
cursor buttons, the Alpha Wheel, the Plus/Minus buttons, or the Chan/Bank buttons) also sends
corresponding program change commands to the K2661’s MIDI Out port.
The nature of these commands depends on the value of the ProgChgType parameter. The K2661
sends either an MC 0 or 32 message followed by a PCH (when ProgChgType is QA Ext), or a
pair of PCHs (when ProgChgType is QA Kurz) or a single Program Change command (when
ProgChgType is QA 0–127). The following tables give specific examples.
Current
QA Bank
Entry From
Alphanumeric Pad
Commands Sent
MC 0 or 32 PCH
10010
19019
20020
29029
99099
10 0 1 0
19 9 1 99
20 0 2 0
29 9 2 99
75 9 7 59
100 0 0 0
105 9 0 59
110 9 1 99
117 7 1 77
119 9 1 99
Table 10-2 QA Extended Program Change Examples
Current
QA Bank
Entry From
Alphanumeric Pad
Commands Sent
1 0 100 10
1 9 100 19
2 0 100 20
2 9 100 29
9 9 100 99
10 0 101 0
19 9 101 99
20 0 102 0
29 9 102 99
75 9 107 59
Table 10-3 QA Kurz Program Change Examples