To Next Page

To Previous Page

Song Mode and the Song Editor

Song Editor: Track Functions

12-57

Shift

The Shift function allows you to offset the existing MIDI events forward or backward in time

any number of ticks (1/480th of a Beat) up to approximately 26 Beats. This function does not

affect the End point.

Events can not be shifted beyond the End point or before Bar 1 : Beat 1. The events can be shifted

only as far as these temporal boundaries. All events that can’t be shifted the full Ticks amount

will be placed at the boundary location.

EditSong:TRACK|||||||||||||||<>Track:1||

Function:Shift|||d|From||:||1:1|To:||2:1

Ticks|||:0.000|||d|Events:Pitchbend|||||

|||||||||||||||||d||||||||||||||||||||||

Locate||:||1:1|||'%%^^^^^^^^%%%%%%^%%%%%

FromTo||Play|||Stop||||||||||Go||||Done|

Ticks: -26.020 – 26.020 (Beats and Ticks, 480 Ticks = 1 Beat)

The Ticks parameter speciﬁes the number of Beats and Ticks that the MIDI events, from within

the selected region, are moved forward or backward in time relative to their original locations.

Transpose

Use the Transpose function to change the MIDI Note numbers of the selected Note events.

EditSong:TRACK|||||||||||||||<>Track:1||

Function:Transposd|From||:||1:1|To:||2:1

Semitone:12ST||||d||||||||||||||||||||||

|||||||||||||||||d|LoKey|:C|-1||Hi:G|9||

|||||||||||||||||d|LoVel|:1|||||Hi:127||

|||||||||||||||||d||||||||||||||||||||||

Locate||:||1:1|||'%%^^^^^^^^%%%%%%^%%%%%

FromTo||Play|||Stop||||||||||Go||||Done|

Semitone: -128ST – 127ST

An increment of one semitone represents a change of one MIDI Note number. You can transpose

Note events only within the range of MIDI Note numbers 0 to 127.

Change

The Change function is used to modify attack velocities, release velocities, or the values of any

existing controller data on the current track. A static change of values can be made as well as

having the change take place over a region of time.

Change can not modify or add data that doesn’t exist on the current track. If you hear note

events played back on a track, then you know there is an attack and release velocity value for

each one, and the effect of the Change function can usually be easily detected. Controller values

Kurzweil K2661 User Manual

Other manuals for Kurzweil K2661