7-20
Setup Mode and the Setup Editor
Controllers
To get an idea of the expressive capabilities of Setup mode, explore the factory setups that come
with the K2661.
The K2661’s physical controllers include the following:
• The eight sliders (A, B, C, D, E, F, G, H) in the Assignable Controllers section
• The two Continuous Control Pedal jacks (CCPedal 1 and CC Pedal 2)
• The Large Ribbon, which you can define as a one- or three-section controller
• The Pitch Wheel
• The Modulation Wheel (Mod Wheel)
• Keyboard aftertouch, or Mono Pressure (MPress)
• The Breath Controller jack (which is connected to Continuous Controller Pedal 2)
• The two Panel Switches, located above the Pitch and Mod Wheels
• The four Footswitch pedal jacks (1, 2, 3, and 4)
The following tables and illustration provide an overview of the physical controllers and their
parameters.
Continuous Controllers
Physical Controller
Setup Editor
Page
Parameter:Values
Sliders A, B, C, D, E, F, G, H SLID, SLID/2
Destination: MIDI Control Source list
Scale: -300% to 300%
Add: -128 to 127
Curve: Linear, Expand, Compress, Crossfade,
Bump, Reverse Linear, Reverse Expand, Reverse
Compress, Reverse Crossfade, Reverse Bump
Entry Value: None, 0 - 127
Exit Value: None, 0 - 127
CPedals 1 & 2 / Breath CPEDAL (same as Sliders)
Large Ribbon RIBBON (same as Sliders)
Pitch Wheel and Mod Wheel WHEEL (same as Sliders)
MPressure PRESS (same as Sliders)
Table 7-3 Continuous Controllers
To Next Page
Loading...
