Kurzweil K2661 - Fxbus

15-2
Advanced KDFX
Navigating KDFX
Figure 15-1 The KDFX User Interface
To select a studio, go to the main Effects page if you’re not already there (from Program mode,
press Effects to go into Effects mode.
KDFXMode:MAIN||||FXCtrl:Auto||||<>Enable
Studio:113|PltEnvFI4T|Plate|||||||Free:0
FX1|||43|Plebe|Chamber||||||||-|||Size:1
FX2|||902|Synth|Env|Filter||||B|||Size:2
FX3|||735|Bap|ba_da_dap|||||||-|||Size:1
FX4|||0|None||||||||||||||||||B|||Size:0
Aux|||103|BigPredelayPlate||||B|||Size:3
MAIN||CTRL|||EQBYP||FXBYP||BUSMUT|Enable|
FXBus
When the studio is highlighted, pressing Edit goes to the Studio Editor (EditStudio) level, and
the FXBUS page. There are four FXBUS pages, one for each FXBus in the studio. These four
buses are the inputs to KDFX, and receive the output from the K2661’s sound engine, as defined
on the OUTPUT page in the Program Editor.
Select the desired FXBUS page using the Channel/Bank Up and Down buttons. If you have just
entered the Studio Editor, the first FXBUS page you see will be the one for FXbus1. Once you are
FXBus 4
Input D
Input C
Input B
Input A
Chan/Bank
AuxFX
Output
FXBus 3
FXBus 2
FXBus 1
algorithm
param 1
Edit
Edit
Name
Save
Delete Dump
<more>
Name
<more>
param 2
Save Delete Dump
Edit
Name
<more>
param 2
Save Delete Dump
Chan/Bank
(if mono)
Studio
FX Preset (Aux)
FX Preset (1-4)
algorithm
param1
Studio|
Effects Mode
Insert FX