Programming Examples
20-11
Example 6
Editing a Setup for KB3 Control
1. Go to Setup mode, and select 97 ControlSetup.
2. Press Edit to enter the Setup Editor.
3. Press the more> soft button, then press the FOOTSW soft button.
4. Use the cursor buttons to highlight TapTempo (it’s the value of the Dest parameter for
FtSw4).
5. On the alphanumeric button pad, press 6 8 Enter. This changes the value to LegatoSw,
which is MIDI 68 (for VAST programs, MIDI 68 will now control Legato Switch, but for
KB3 programs, it will switch between slow and fast rotary speaker effect).
6. Press the more> soft button, then press the RIBBON soft button.
7. Highlight AuxBend2 (it’s the value of the Dest parameter for SmRib).
8. On the alphanumeric button pad, press 1 6 Enter. This changes the value to Ctl A, which is
MIDI 16.
9. Highlight MPress (it’s the value of the Dest parameter for SmPrs).
10. On the alphanumeric button pad, press 1 7 Enter. This changes the value to Ctl B, which is
MIDI 17.
11. Highlight AuxBend1 (it’s the value of the Dest parameter for LgRib—or Sect1 if the large
ribbon is configured in three sections).
12. On the alphanumeric button pad, press 1 8 Enter. This changes the value to Ctl C, which is
MIDI 18.
13. Press the SWITCH soft button.
14. Highlight ArpSw (it’s the value of the Dest parameter for PSw1—Button 9 above the Pitch
Wheel).
15. On the alphanumeric button pad, press 6 9 Enter. This changes the value to FrezPd, which
is MIDI 69.
16. Highlight MIDI29 (it’s the value of the Dest parameter for PSw2—Button 10 above the
Mod Wheel).
17. On the alphanumeric button pad, press 7 0 Enter. This changes the value to MIDI70.
18. Press Exit. The K2661 will ask you if you want to save the setup. Press the Rename soft
button.
19. Press either Chan/Bank buttons until the KbdNaming parameter in the top line of the
display shows a value of Adv. This lets you rename the setup by playing notes (in this
example, we’re going to rename it as KB3 Setup). Of course, if you prefer, you can use soft
buttons and data entry (Alpha Wheel, cursor buttons, or alphanumeric button pad) to
rename the setup.
To Next Page
Loading...
