Kurzweil K2661 - The Continuous Control Pedal (CPEDAL) Page; The RIBBON Page

Setup Mode and the Setup Editor
The Continuous Control Pedal (CPEDAL) Page
7-27
The Continuous Control Pedal (CPEDAL) Page
If you look at the back of the instrument, you will see that there are jacks for plugging in two CC
(Continuous Control) pedals. There is also a jack labeled Breath Controller. This jack is wired in
parallel with CC Pedal 2; in other words, you can send MIDI 02 Breath (or any other MIDI or
global Controller) with both CC Pedal 2 and an breath controller.
EditSetup:CPEDAL||||||||||||||<>Zone1/1|
||||||||||||||||||||||||||||||||||||||||
|||||||Dest:|||Scale:Add:Curv:Ent:|Exit:
CPed1:|Foot|||||100%|0|||Lin||None|None|
CPed2:|Breath|||100%|0|||Lin||None|None|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
<more||SLIDER|SLID/2|FOOTSW|CPEDAL|more>
The RIBBON Page
The RIBBON page lets you define controller assignments for the K2661’s ribbon controller. Each
ribbon senses movement when you press on it and move your finger left or right; this creates
numerous possibilities for controlling pitch, volume, panning, crossfades between zones, or any
other uses you might imagine.
The Large Ribbon can be used as a single long controller, or it can be divided into three separate
sections, each with its own controller assignments (this is done on the RIBCFG page). The two
small arrows above the strip indicate the boundaries of the three sections. The large arrow above
the ribbon points to the center of the ribbon, for when the ribbon is configured in one section.
The K2500 and K2600 had a small ribbon physical controller as well. Small Ribbon parameters
are still included, for compatibility with K2600 and K2500 setups.
To modify other ribbon parameters, go to the RIBCFG page, which is described on page 7-42.
Parameter Range of Values Default
Destination (CPed1) MIDI Control Source list Foot
Destination (CPed2) MIDI Control Source list Breath
Scale ±300% 100%
Add -128 to +127 0
Curve Curve list (see text) Lin
Entry Value None, 0–127 None
Exit Value None, 0–127 None