Kurzweil K2661 - Page 146

7-26
Setup Mode and the Setup Editor
The SLIDER and SLID/2 Pages
Take a look at the parameters. Since all the continuous controllers work in a similar manner,
you’ll find these same parameters on the CPEDAL, RIBBON, WHEEL, and PRESS pages.
EditSetup:SLIDER||||||||||||||<>Zone1/1|
||||||||||||||||||||||||||||||||||||||||
|||||||Dest:|||Scale:Add:Curv:Ent:|Exit:
SlidA:|Data|||||100%|0|||Lin||None|None|
SlidB:|MIDI22|||100%|0|||Lin||None|None|
SlidC:|MIDI23|||100%|0|||Lin||None|None|
SlidD:|MIDI24|||100%|0|||Lin||None|None|
<more||SLIDER|SLID/2|FOOTSW|CPEDAL|more>
EditSetup:SLID/2||||||||||||||<>Zone1/1|
||||||||||||||||||||||||||||||||||||||||
|||||||Dest:|||Scale:Add:Curv:Ent:|Exit:
SlidE:|MIDI25|||100%|0|||Lin||None|None|
SlidF:|MIDI26|||100%|0|||Lin||None|None|
SlidG:|MIDI27|||100%|0|||Lin||None|None|
SlidH:|MIDI28|||100%|0|||Lin||None|None|
<more||SLIDER|SLID/2|FOOTSW|CPEDAL|more>
NOTE: The FOOTSW page, and all the switch-controller pages, are described following the section
called Switch Controller Parameters, which begins on page 7-30.
Parameter Range of Values Default
Destination (Slider A) MIDI Control Source list Data
Destination (Slider B) MIDI Control Source list MIDI 22
Destination (Slider C) MIDI Control Source list MIDI 23
Destination (Slider D) MIDI Control Source list MIDI 24
Destination (Slider E) MIDI Control Source list MIDI 25
Destination (Slider F) MIDI Control Source list MIDI 26
Destination (Slider G) MIDI Control Source list MIDI 27
Destination (Slider H) MIDI Control Source list MIDI 28
Scale ±300% 100%
Add -128 to +127 0
Curve Curve list (see text) Lin
Entry Value None, 0–127 None
Exit Value None, 0–127 None