Kurzweil K2661 - The LAYER Page; Low Key (Lokey); High Key (Hikey)

Program Mode and the Program Editor
The LAYER Page
6-19
The LAYER Page
Press the LAYER soft button to call up the LAYER page. Here you’ll set a number of parameters
that affect the current layer’s keyboard range, attack and release characteristics, and response to
various controls.
EditProg:LAYER|||||||||||||<>Layer:1/1||
LoKey|:C|0||DlyCtl:OFF|||||||SusPdl:On||
HiKey|:C|8||MinDly:0.000s||||SosPdl:On||
LoVel|:ppp||MaxDly:0.000s||||FrzPdl:On||
HiVel|:fff||Enable:ON||||||||IgnRel:Off|
PBMode:All||S:Norm|64||127|||ThrAtt:Off|
Trig||:Norm|Opaque:Off|||||||TilDec:Off|
<more||ALG||||LAYER||KEYMAP|PITCH||more>
Low Key (LoKey)
This sets the lowest active note for the current layer. This parameter’s value cannot be set higher
than the value for HiKey. The standard MIDI key range is C -1—G 9 (0-127). Middle C is C 4
(ISP).
High Key (HiKey)
Here you set the highest active note for the current layer. This parameter’s value cannot be set
lower than the value for LoKey.
Parameter Range of Values Default
Low Key C -1 to G 9 C 0
High Key C -1 to G 9 C 8
Low Velocity ppp to fff ppp
High Velocity ppp to fff fff
Pitch Bend Mode Off, Key, All All
Trig Normal, Reversed Normal
Delay Control Control Source list Off
Minimum Delay 0 to 25 seconds 0
Maximum Delay 0 to 25 seconds 0
Layer Enable Control Source list On
Enable Sense
Enable Min
Enable Max
Normal, Reversed
-128 to 127
-128 to 127
Normal
64
127
Opaque Layer Off, On Off
Sustain Pedal Off, On, On2 On
Sostenuto Pedal Off, On On
Freeze Pedal Off, On On
Ignore Release Off, On Off
Hold Through Attack Off, On Off
Hold Until Sustain Off, On Off