Kurzweil K2661 - Page 76

6-18
Program Mode and the Program Editor
The Algorithm (ALG) Page
Note: Changing a layer’s algorithm can affect the layer’s sound drastically. It’s a good idea to bring
down the volume of your K2661 or your sound system before changing algorithms.
The five downward-pointing arrows represent inputs to the DSP functions that are available for
the current algorithm. Each input arrow has its corresponding page. The first arrow points to the
PITCH function. The soft button for the PITCH page is already visible. Press it to view the
parameters affecting pitch for the currently selected layer. The buttons for the other four DSP
functions are not visible when you first enter the Program Editor. To see them, press the more>
soft button (on the right side of the page). You’re still on the same page, but the soft buttons’
labels change to let you select a different set of pages, as the diagram below shows.
Figure 6-3 DSP Function Inputs
The pages (F1–F4) that control the DSP functions are described later in this chapter. Algorithm
Basics on page 6-12 gives general information on algorithms, while Chapter 16 gives a thorough
description of each the DSP functions and the parameters found on their editing pages.
EditProg:ALG|||||||||||||||<>Layer:1/1||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
errR®rrte11231111112311111123114errR®rt|
dPITCH|gkHIFREQ|STIMULATOR|||||0kAMP||gh
CVVVVVVBCVVVVVVVVVVVVVVVVVVVVVVBCVVVVVB|
||||||||||||||||||||||||||||||||||||||||
<more||F1|FRQ|F2|DRV|F3|AMP|F4|AMP|more>
Pitch Control
Parameters
F1:
Frequency
Control
Parameters
F2:
Drive Control
Parameters
F3:
AMP Control
Parameters
F4:
Final AMP
Control
Parameters