7-46
Setup Mode and the Setup Editor
Editing Hints and Suggestions
equal to 64, and <64 means less than 64. >0 means you can use any value that’s greater than
zero. x means you can use any value.
Do I Need All Those Pedals?
It’s important to realize that you don’t have to have an actual pedal plugged into every Pedal
and Switch Pedal jack in order to take advantage of all of them. Entry and exit values can be
assigned to a zone and to a physical controller’s destination even if the controller isn’t there, and
they will behave as if the controller were in fact plugged in. So if you want a specific group of
Controller commands to be sent out whenever you choose a setup, and you know they’re not
going to change while you’re playing, you can assign them as the destinations of physical
controllers that aren’t in use.
Multiple Controllers
Sometimes you’ll want to assign the same Controller number as the destination of more than
one physical controller. For example, you might want to be able to control modulation depth
both with Wheel 2 and with pressure. The K2661 has no restrictions on assigning multiple
physical controllers to a particular MIDI Controller.
Editing Programs
Remember, except for control-setup parameters, everything you define in a setup affects
programs only while you are in Setup mode. To edit the programs themselves while you are in the
Setup Editor, go to the CH/PRG page and press Edit. This gives you access to the other editors
nested within the Program Editor as well. When you have finished editing your program, press
Exit to save it and return to the Setup Editor.
MIDI
Controller
Number
MIDI Controller On Value Off Value
102 Play/Stop >=64 <64
103 Record/Stop >=64 <64
120 All Sound Off >=64 <64
121 Reset All Controllers >=64 <64
122 Local Control Off >=64 <64
123 All Notes Off >=64 <64
124 Omni mode Off >=64 <64
125 Omni mode On >=64 <64
126 Mono mode On (the On value, in some synths,
specifies the number of MIDI channels to
respond to, with one voice on each)
>=64 <64
127 127 Poly mode On >0 x
Table 7-6 Little-used MIDI Control Sources
To Next Page
Loading...
