Kurzweil K2661 - Editing Macros

To Next Page

To Previous Page

Disk Mode

Macros

13-53

2. Have a lot of macro ﬁles that load similar lists of ﬁles.

If the Open button is pressed from a disk function other than Load, you will see the VIEW

MACRO page:

Func:VIEW|MACRO|||Sel:0/4||||Index:|||1|

||||||||||||||||||||||||||||||||||||||||

|5:\ANALOG\MULTIVOX.K26||||||||200:F:|||

|5:\ANALOG\NOISE.K26|||||||||||200:F:|||

|5:\ANALOG\RESONANT.K26||||||||200:F:|||

|5:\ANALOG\SYNAPSE.K26|||||||||200:F:|||

|||||||||||||||||||||||||||||||||||Exit|

The only function of this dialog is to view the Macro table entries stored in a macro ﬁle. This

feature is useful when, for example, you are about to delete a macro ﬁle and want to know what

information is contained in the ﬁle before you remove it from the disk.

Editing Macros

The RAM Macro table can be edited from the MACRO page. You can select one or more macro

entries and execute any of the following operations on them:

1. Change the Disk ID.

2. Change the bank and mode settings.

3. Delete the selected macro entries.

To edit a macro ﬁle already saved on your disk, it is necessary to ﬁrst load the macro ﬁle into the

RAM Macro table:

Making sure that Macro Record mode is enabled, go to the Load function, highlight the macro

ﬁle you wish to edit, and then either select certain entries from the macro ﬁle (by pressing Open

to get to the LOAD MACRO page), or just press OK to load the entire macro ﬁle. When you see

the following display, press the Macro soft button, so that the K2661 will not load the ﬁles listed

in the macro.

||||||||||||||||||||||||||||||||||||||||

|Load|this|macro|as:specified|||||||||||

||||||||||||||||||||200...299|||||||||||

||||||||||||||||||||300...399|||||||||||

||||||||||||||||||||400...499|||||||||||

Insert||||||||||||||||Macro|||OK||Cancel

If you want, you can rebank the macro by scrolling the bank list to something other than

speciﬁed. Similarly, if you override the load mode, it also will be reﬂected in the RAM Macro

table.

To edit entries from the Macro table, return to the MACRO page. For this example we will edit

all the entries at once (like other similar dialogs, if you are concerned with only one list entry, it

Other manuals for Kurzweil K2661