Program Mode and the Program Editor
Programming Tips
6-61
Using the VAST Program Editor on a KB3 Program
KB3 Mode lets you use certain VAST-related parameters— such as the !AMP DSP function
mentioned above—that are not found within the KB3 editor. There’s a “back door” that takes
you to these non-KB3 parameters: if you mark a page (with the Mark button) while editing a
VAST program, you can jump to that page (with the Jump button) while you’re editing a KB3
program.
When editing a KB3 program, we recommend that you edit only those parameters on the
KB3-editing pages. We realize, however, that some power users (you know who you are!) will
want to hear the results of applying VAST parameters to KB3 programs. Before you start
experimenting, please be aware of the following:
• Turn your volume down! In KB3 mode, most resources are being used in much different
ways than they in a typical VAST program; the results of applying VAST parameters to KB3
programs can be extremely unpredictable.
• Most changes made to these parameters do not take effect until save the program and
reselect it.
• You cannot import a KB3 program layer into a regular VAST program.
To Next Page
Loading...
