Kurzweil K2661 - Continuous Controller Parameters

Setup Mode and the Setup Editor
Continuous Controller Parameters
7-23
Continuous Controller Parameters
The continuous (physical) controllers are those that have a range of values: the two wheels, the
ribbon, eight sliders, two Continuous Control pedals, and mono pressure (aftertouch). As the
65 PortSw Monophonic K2661 programs respond to this controller if
portamento is turned on
66 SostPd Default destination for Footswitch 2–holds notes that are
currently down, but not notes played subsequently
67 SoftPd Default destination for Footswitch 3– lowers the volume by a
preset amount and may soften the timbre as well
68 LegatoSw Forces mono playback
69 FrezPd Envelopes freeze at current state
70–79 MIDI 70–79 MIDI Controllers 70–79
80 Ctl E
81 Ctl F
82 Ctl G
83 Ctl H
84–90 MIDI 84–90 MIDI Controllers 84–90
91 FX Depth Controls wet/dry mix of effects
92–95 MIDI 92–95 MIDI Controllers 92–95
96 DataInc Data Increment
97 DataDec Data Decrement
98–101 MIDI 98–101 MIDI Controllers 98–101
102 Play/Stp Alternately starts and stops sequencer playback
103 Rec/Stop Alternately starts and stops sequencer recording
104–115 MIDI 104–115 MIDI Controllers 104–115
116 ArpSw Arpeggiator On/Off
117 ArpVel Arpeggiator Velocity
118 Latch2 Arpeggiator Latch 2
119 ArpLatch Arpeggiator Latch
120 Panic2 Sends All Notes Off message
121 MIDI 121 Resets all controllers
122 Off Turns physical controller off
123 Panic Sends All Notes Off message
124, 125 MIDI 124, 125 MIDI Controllers 124 and 125
126 Mono On
127 Poly On
MIDI
Controller
Number
Corresponding
Destination
Name
Description
Table 7-5 MIDI Control Source List (Continued)