Program Mode and the Program Editor
The KEYCLK Page
6-55
KeyClick
This is where you turn Key Click on or off.
Volume
This parameter sets the level of the keyclick; the noise decays from the level you set here. This
level is scaled by the drawbar levels, as well as the expression pedal level.
Decay
Sets the basic decay time of the noise envelope. Smaller values produce a shorter burst.
Pitch
Sets the basic pitch of the key click noise, relative to the highest tone wheel’s pitch. The pitch is
actually controlled by a steep lowpass filter applied to white noise.
VelTrk
Controls the degree to which key velocity affects the key click volume. A value of zero means
that the key velocity has no effect on the key click volume (which is like a real tone wheel organ).
Other values add volume as the velocity increases.
Random
Controls the degree to which a random amount of amplitude variation is added to the key click.
ReTrigThresh
This parameter lets you set the volume level below which key click must decay before it will be
retriggered.
Parameter Range of Values
Key Click Off, On
Volume -96.0 to 0.0 dB, in .5-dB increments
Decay Time 0.005 to 1.280 seconds, in .005-second increments
Pitch -129 to 127 Semitones
Velocity Tracking 0–100%
Random 0–100%
Retrigger Threshold -96.0 to 0.0 dB, in .5-dB increments
Note Attack Normal, Hard, PercHard
Note Release Normal, Hard
To Next Page
Loading...
