20-12
Programming Examples
20. Hold down G 6, then strike D 4 (or do the equivalent on your MIDI source). This enters a
K as the first character in the name.
21. Hold down G 6 and strike B 2 to enter a B.
22. Release G 6, then press A
#
2 to enter a 3.
23. Strike G
#
6 three times to delete three characters. Notice how the remaining characters
shift to the left.
24. Strike G 2 to enter a space. You’re finished renaming.
25. Press OK. The save dialog reappears. Change the setup’s ID if you want, then press Save.
You’ll return to Setup mode.
Example 7
Using the KB3 Setup From the SmartMedia Card
1. Insert the SmartMedia card provided with your K2661 into the K2661’s SmartMedia slot.
2. Set the value of the CurrentDisk parameter to SMedia, if it isn’t already there.
3. Use the cursor buttons to highlight the directory called MOREPRGS, then press
Open or OK.
4. Highlight the file KB3.K26, if it isn’t already highlighted. Press OK. The K2661 prompts
you to select a memory bank.
5. Select a different bank if you wish, then press OK.
6. Press Fill, which determines how the K2661 assigns an ID to the file you’re loading. This
loads the file into the first available ID in the bank you selected—without affecting any
objects already stored in the bank. When the file has loaded, the K2661 will return to the
Disk-mode page.
7. Press the MIDI mode button, then press the XMIT soft button.
8. Highlight the value of the CtlSetup parameter, then press 2 0 0 Enter on the alphanumeric
buttonpad.
To Next Page
Loading...
