Kurzweil K2661 - Page 368

13-54
Disk Mode
Macros
does not need to be explicitly selected with the Select soft button). You can use the following
double-presses to select and deselect all entries in the list:
• Left/Right cursor double-press: Select all macro entries
• Up/Down cursor double-press: Clear all selections
With all the entries selected, our display looks like this:
Func:MACRO|[Record]||||||||||Index:|||1|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
*4:\NEWMIX\TRASHX12.K26||||||||200:F:|||
*4:\POTS\TEAPOT.K26||||||||||||300:F:|||
*4:\PANS\FRYING.K26||||||||||||400:F:|||
*4:\KITCHEN\SINK.K26|||||||||||500:F:Obj
Select|Modify||Load||Pause|||Off|||Exit|
The two remaining soft buttons are Modify and Load.
Press the Modify soft button to change any items mentioned at the top of this section. You will
see the following display:
Modify|Macro|Entries||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Modify:Drive||||||||||||||||||||||||||||
Drive|:SCSI|4|||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
4|entries|selected.|||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||Delete||OK|||Cancel
Use the Drive parameter to change the Disk ID for the selected macro entries. This is where you
would set the entries’ Disk IDs to be Unspecified or Library. If you increment the Modify
parameter, the display switches to let you modify bank and mode information:
Modify|Macro|Entries||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Modify:Bank/Mode||||||||||||||||||||||||
Bank||:200's||||||Mode:Fill|||||||||||||
||||||||||||||||||||||||||||||||||||||||
4|entries|selected.|||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||Delete||OK|||Cancel
The initial settings of the parameters on these pages are always taken from the lowest-indexed
macro entry that is selected on the MACRO page. In addition, every time you return to the
“Modify Macro Entries” page, both the Modify parameter and the highlighted value will be the
same.
Pressing OK will set all of the selected macro entries to have Disk ID or bank and mode settings
according to the parameters set up on this page. The display will return to the MACRO page