Setup Mode and the Setup Editor
Setup Mode
7-3
The default control setup is 97 Control Setup, but you can choose any control setup you want.
To do this, go to the MIDI-mode TRANSMIT page and use any normal data entry method to
change the CtlSetup parameter. When you reenter Program mode, all programs will now
respond to many of the controller assignments defined in Zone 1 of the control setup (Zones 2–8
are not relevant in Program mode, because a program can occupy only one MIDI channel).
To edit the control setup, press the Edit button while the CtlSetup parameter is highlighted on
the MIDI-mode TRANSMIT page. This brings you to the Setup Editor, which is described in the
following sections. The following table shows which control-setup parameters affect controller
assignments in Program mode.
In summary, physical controller destinations, their curves and states, and the Arpeggiator
parameters all define controller assignments for programs in Program mode. The other
parameters have no effect; this keeps Program mode relatively simple. Program mode lets you
change values for transposition, MIDI channels, and programs independently of the control
setup.
Once you save changes to the control setup, those changes will affect all programs when you are
in Program mode. For example, programming the Large Ribbon in the control setup to have
three sections will mean that in every program in Program mode, you will have a three-section
Large Ribbon.
You may want to program several different control setups, and switch among them for different
applications. Suppose, for example, that you’re recording a song, but you don’t want to record
aftertouch. You can create a setup with pressure turned off in Zone 1 (on the PRESS page in the
Control Setup–Setup
Editor Page, Zone 1
Parameters Affecting
Program Mode
Parameters Not Affecting
Program Mode
CH/PROG ZoneArpeg, Destination,
MIDIBankMode
LocalPrg, Out, Channel, MIDIBank,
MIDIProg, Status, EntryProgChg
KEY/VEL VelScale, VelOffset,
VelCurve
LoKey/HiKey, Transpose, NoteMap,
LoVel/HiVel
PAN/VOL None
BEND All
COMMON Sync
ARPEG All
RIBCFG All
Continuous Controller
assignment pages
(SLIDER, SLID/2,
CPEDAL, RIBBON,
WHEEL, PRESS)
Dest, Scale, Add, Curv Ent and Exit
Switch Controller
assignment pages
(FOOTSW, SWITCH)
SwType, Dest, On, Off Ent and Exit
KDFX, FXMOD2,
FXMOD3, FXMOD4,
FXLFO, FXASR, FXFUN
None
Table 7-1 Control Setup Parameters Affecting Program Mode
To Next Page
Loading...
