Basic Effects Mode
A More Complex Studio
9-29
Outputs
Finally, press the OUTPUT soft button to get to the OUTPUT page. Here we see that the four
physical output pairs are each passing different parts of the studio. If the outputs are connected
to an external mixer, you can treat each of them separately: recording them on different tracks of
a tape deck, sending them to different outboard processors, or mixing them differently in a
monitor mix.
Output A has the Mix bus. This is the combined output of the two FXBuses, plus the reverb on
the Aux bus. Its gain and balance are at unity.
Output B has the output of FXBus1, that is, the ring-modulated piano, without any reverb.
Output C has the output of FXBus2, the delayed/flanged/ flute, without any reverb.
Output D has the output of the Aux bus, which is just the reverb signal, with no dry component,
since the value of Wet/Dry on the AUXFX page is 100%.
Note: If you’re using the Mix audio outputs, keep in mind they carry the summed signals of audio
outputs A through D. Normally you would assign each of the audio outputs differently. In the example
above, you might set Outputs B through D to Off, or Output A to Off, to avoid overlapping assignments.
Here is the overall structure for this studio:
Figure 9-5 Structure of Studio 201
EditStudio:OUTPUT||||||||||||||||||||||||
Mix|Lvl:0.0dB||||||Output|A:Mix
Mix|Bal:0%|||||||||Output|B:FXBus1
|||||||||||||||||||Output|C:FXBus2
|||||||||||||||||||Output|D:AuxFX
<more||FXSEND|AUXFX||OUTPUT||||||||more>||
Program
output A
EQs
FXBus1
Tut Ring Mod
AuxFXBus
MedWarmPlate
FXBus2
Ptc+Flg+Dly145BP
output B
-5dB
Mix
+
Physical
output A
-2.5dB
-9.5dB
Output B
Output C
Output D
To Next Page
Loading...
