Kurzweil K2661 - Page 381

To Next Page

To Previous Page

Disk Mode

Backup and Copy Functions

13-67

Select a directory to be backed up (see The Directory Selection Dialog on page 13-13). Backup

allows you to copy all of the ﬁles within a directory from one disk to another. All of the ﬁles

within the directory that you choose (plus all of its subdirectories and the ﬁles within them) will

be copied to the new disk. If you want to backup the entire disk, then make sure the current

directory is the root directory (as in the picture), and press Current.

Next, you will see a dialog for choosing the destination disk:

||||||||||||||||||||||||||||||||||||||||

||||Destination|disk:SCSI|0|||||||||||||

|||||||||||||||||||||SCSI|1|||||||||||||

|||||||||||||||||||||SCSI|2|||||||||||||

|||||||||||||||||||||SCSI|3|||||||||||||

|||||||||||||||||||||||||||||OK|||Cancel

Select the disk you wish to transfer ﬁles to. It must be different from the current disk.

Next, you can select a directory on the destination disk that will receive the transferred ﬁles.

||||||||||||||||||||||||||||||||||||||||

Use|default|directory|on|SCSI|0?||||||||

(Path|=|\)||||||||||||||||||||||||||||||

||||||||||||||||||||||||||||||||||||||||

|||||||||||||||||||||Change||OK|||Cancel

The default is always the root directory on the destination disk. Press OK to select the default.

To select a different directory, press Change.

Next, select the Backup mode when you see the following question:

||||||||||||||||||||||||||||||||||||||||

Replace|or|increment|mode?||||||||||||||

||||||||||||||||||||||||||||||||||||||||

|Help||||||||||||||Replace|Increm|Cancel

Replace Any ﬁles to be transferred that already exist in the destination directory will be

replaced (overwritten).

Increm Any ﬁles to be transferred that already exist in the destination directory will be

skipped (not transferred).

Help Displays a reminder about the meaning of Replace and Increment modes.

Other manuals for Kurzweil K2661